AGCO LELY ATTIS PT 130, Operator'S Manual

Page: 34 / 98

2.5 E-Link basic software
2.5.1 Function of the buttons
The E-Link basic controller has the buttons shown in the table below:
Number Button/Switch Auto Function Manual Function
1. Display.
2. Emergency stop.
3. Adds one turn to the total number of turns or temporarily stops the
count operation for the number of turns.
4. The set/reset button. Set a number in cal mode or sets the field bale
count and bales per hour to zero again.
5.
(Up)
Lifts the machine's table to release the bale.
(Down)
Lowers the machine's table after the bale release is complete.
6.
(Up)
Not applicable. Turns the machine's table slowly
in the opposite direction.
(Down)
Hold down for three seconds to
engage auto wrap.
Turns the machine's table at high
speed.
7. Change the display.
8.
(Up)
Not applicable. Closes the film cutter.
(Down)
Not applicable. Opens the film cutter.
9.
(Up)
Lifts the loader arm.
(Down)
Lowers the loader arm.
10. The calibration button sets the number of turns and the safety alarm.
11. Changes between auto or manual mode.
2.5.2 Interface structure
The E-Link basic controller has six different display screens.
[V]
GUID-405ADAD5-99C0-4CA6-8CF3-6DD13D9E8856 [V1]
GUID-548F36DF-FDD0-4C80-9816-23D7A7BAE8D7 [V1]
2. Introduction
34 Bale Wrapper
4820.LE.EN01