AGCO LELY ATTIS PT 130, Operator'S Manual

Page: 17 / 98

2. Make sure that the temperature of the installation surface is not less than 5 °C.
3. Find the correct position for the decal before you remove the protective paper.
4. Remove a small part of the cover paper.
5. Put the decal in the correct position on the install surface and carefully push the small part of the shown
adhesive surface of the decal on to the install surface.
6. Slowly remove the protective paper and attach the decal to the install surface.
7. Make small air holes in the decal with a pin and use the cover paper to make sure that the decal is flat.
Maintenance of Safety Decals
Safety decals show important data and data that you can use that will help you to safely operate and do
maintenance on the machine.
Obey the instructions to make sure that all the decals stay in the correct position and condition:
• Keep the safety decals clean and in good condition at all times. Clean the safety decals with soap and
water. Do not use mineral spirits, abrasive cleaners or other agents that can cause damage to the safety
decals.
• Replace safety decals that are not on the machine or are in bad condition.
• Get replacement safety decals from your approved local dealer.
1. Safety
Bale Wrapper 17
4820.LE.EN01