ADTRAN TOTAL ACCESS 600R, System Manual

Page: 91 / 196

Total Access 600R System Manual Section 4 User Interface Guide
61200600L1-1A © 2002 ADTRAN, Inc. 91
S
ERV
A
DDR
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This is the
destination of the packet.
P
ROTO
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This shows the
protocol used (
TCP, UDP, ICMP
, etc.).
P
RIV
P
ORT
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This is the
private port used for the entry.
S
POOF
P
ORT
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) If the same
private port is already used in the table, it will spoof a different port for the entry.
S
ERVER
P
ORT
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This port is used
on the public side.
T
IME
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This is the time
since the entry was last used.
I
N
C
NT
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This is the
number of packets that came in.
O
UT
C
NT
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This is the
number of packets sent out.
NAPT A
DDRESS
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This represents the
public address that is being used as the NAPT address. Read-only.
E
NTRY
C
OUNT
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This is the number of
entries in the NAT table. Maximum is 1500.
E
NTRY
O
VERFLOW
C
OUNT
(This option is only available when NAT P
ORT
T
RANSLATION
is enabled.) This is a count of the
dropped entries due to entry count being 1500 or greater; i.e., the NAT table is full.