ADTRAN TOTAL ACCESS 600R, System Manual

Page: 172 / 196

172 © 2002 ADTRAN, Inc. 61200600L1-1A
Section 5 DLP-013 Total Access 600R System Manual
Entering Commands at the Command Prompt
To do this manually from the prompt, precede each instruction with a ">". After uploading, to apply and
save changes, you must issue the command "save" from the prompt. The command will apply ALL
changes to the unit (the same as escaping all the way out of the terminal menu). To do a save to flash only,
but not apply the changes, you can go back to the menu system and press <Ctrl + W>. A
!exit command
executes a do not save and a do not ask function (i.e., changes will not be saved and the user will not be
prompted to save the changes).
The commands are based on string comparisons with the menu system (with spaces replaced with
underscores). This means that the config command will appear exactly as it appears in the terminal menus.
To change a configuration, type in the option desired exactly as it appears on the menu. For example, to
change the T1 timing mode, the command line would read
>sysconfig t1_timing_mode network or
>sysconfig t1_timing_mode internal or
>sysconfig t1_timing_mode dsx-1.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.