ADTRAN TOTAL ACCESS 600R, System Manual

Page: 51 / 196

Total Access 600R System Manual Section 4 User Interface Guide
61200600L1-1A © 2002 ADTRAN, Inc. 51
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> SNMP M
ANAGEMENT
> T
RAPS
Sets up the trap manager name and IP from this menu.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> FDL M
ANAGEMENT
Enables the FDL management and configures mode and IP addresses from this menu.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> FDL M
ANAGEMENT
> M
ODE
This enables the FDL (only in ESF mode) to be used for management. Learning mode can also be enabled
so the unit can "learn" its IP configuration to be used for its FDL management. Once it learns this
information from, for example a Total Access 4303, the configuration items populate. The factory default
is
O
N
.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> FDL M
ANAGEMENT
> L
INK
IP A
DDRESS
This is the local IP address used for FDL management. The FDL uses a separate IP network for
communication, distinct from the customer data that is configured under the
R
OUTER
menus. The factory
default is
0.0.0.0
.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> FDL M
ANAGEMENT
> IP N
ETMASK
This is the subnet mask defining the IP network used for FDL management. The factory default is
0.0.0.0
.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> FDL M
ANAGEMENT
> F
AR
-E
ND
IP A
DDRESS
This is the far-end IP address used for the FDL management. The FDL is a separate IP network from the
customer data that is configured under the
R
OUTER
menus. The factory default is
0.0.0.0
.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> FDL M
ANAGEMENT
> L
EARN
A
DDRESS
When set to
O
N
, the destination address on each received packet is assumed to be the FDL interface
address. A 255.255.255.252 netmask is used, which determines the far-side address as well (since there can
be only two addresses on a subnet with that netmask). When set to
O
FF
,
the user must input the IP address
assigned to the FDL interface. Default is
O
N
.
#
Displays the index number in the SNMP traps table.
This list allows up to 20 managers to be listed to receive traps.
M
ANAGER
N
AME
is the text string describing the name of the entry. It is intended for easy reference
and has no bearing on the SNMP trap function. You can enter up to 31 characters in this field. The
factory default is no entry in the manager name field.
M
ANAGER
IP
This is the IP address of the manager that is to receive the traps. The factory default is
0.0.0.0
.