ADTRAN TOTAL ACCESS 600R, System Manual

Page: 143 / 196

61200600L1-1A © 2002 ADTRAN, Inc. 143
Total Access 600R System Manual Section 5 DLP-005
3. Telnet to the unit.
From the same computer used in the previous step, Telnet to the unit and verify that the Telnet session
is properly opened (see DLP-006
, Telnetting to the Unit ). Once the Telnet session is established, press
<Ctrl+L>
to log out and close the session.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
Some versions of Ping will continue running until you explicitly tell them to stop. If the
program does not terminate on its own, type
<Ctrl+C>
to get the program to stop.
Refer to the documentation of the computer system if you are unsure how to perform a
Telnet. Most computers running a networked version of Microsoft Windows™ or UNIX
allow a Telnet to be performed by simply typing
Telnet <IP Address> at a command line
prompt. Telnet is a utility common on many local area networks that allows remote access
to another computer or piece of equipment.