ADTRAN TOTAL ACCESS 600R, System Manual

Page: 146 / 196

146 © 2002 ADTRAN, Inc. 61200600L1-1A
Section 5 DLP-006 Total Access 600R System Manual
DLP-006
1. Connect the computer to the unit’s CRAFT port as shown in DLP-001, Connecting the Terminal or PC
to the CRAFT Port .
2. Log in to the unit as shown in DLP-002, Logging in to the System .
3. Select S
YSTEM
C
ONFIG
, M
ANAGEMENT
, and T
ELNET
A
CCESS
.
4. Right arrow to A
UTHEN
M
ETHOD
and press <Enter>. Select P
ASSWORD
, R
ADIUS
, P
ASSWORD
/R
ADIUS
, or
R
ADIUS
/P
ASSWORD
and press <Enter>.
5. Verify the T
ELNET
A
CCESS
is set to O
N
. Down arrow to select U
SER
L
IST
and press <Enter>.
The following screen will appear.
6. Use the right arrow key to select the N
AME
field; press <Enter>. Enter a username to be used for
Telnet logins.
7. If P
ASSWORD
was selected for the A
UTHEN
M
ETHOD
in Step 4, right arrow over to P
ASSWORD
; press
<Enter>. Enter a password to be used for Telnet logins.
8. Use the right arrow key to select I
DLE
T
IME
(
MINS
); press <Enter>. This field defines the amount of time
in minutes the Telnet session may be idle before the user is logged off. The range is 1-255 . The
default value is 10 minutes. Enter the appropriate I
DLE
T
IME
.
9. Use the right arrow key to select L
EVEL
. Select the appropriate security level. For security level
definitions, reference DLP-003 Adding/Removing Telnet Users and Changing Password Security
Levels .
10. This completes the addition of one Telnet user. Repeat Steps 1-9 for each user needing Telnet
access.
Perform Steps Below in the Order Listed