ADTRAN ATLAS 800 Series Module QUAD E1, User Manual, Page: 78 / 190

Chapter 6. Terminal Menu and System Control
6-18 ATLAS 800 User Manual 61200180L1-1
»» IP Address Write security: 5; Read security: 5
Specifies the IP address to ping.
»» Count Write security: 5; Read security: 5
Specifies the number of pings to send. The default number is, and the maxi-
mum value is 99.
»» Size Write security: 5; Read security: 5
Specifies the size in bytes of the data portion of the ping request. The
default value is 64 bytes, and the maximum size is 1024 bytes.
»» Timeout Write security: 5; Read security: 5
Specifies the time in milliseconds to wait for the ping reply before timing
out. The default timeout is three seconds, and the maximum timeout value
is ten seconds.
»» Round trip min Read security: 5
Displays the minimum round trip time of the ping request/reply of the cur-
rent set of pings.
»» Round trip avg Read security: 5
Displays the average round trip time of the ping request/reply of the cur-
rent set of pings.
»» Round trip max Read security: 5
Displays the maximum round trip time of the ping request/reply of the cur-
rent set of pings.
»» Tx Stats Read security: 5
Displays the number of ping requests transmitted (
n txed ), the number of
ping replies received ( n rxed ) and the number of ping requests that were
lost ( n lost ).
»» Reset Stats Write security: 5; Read security: 5
Resets all ping statistics to zero. If the ping client is active, this menu will
stop it.
»» Start/Stop Write security: 5; Read security: 5
If the ping client is currently idle, this menu sends pings to the specified
address. If the ping client is active, the menu sends stops sending pings.
» Reboot System
Write security: 2; Read security: 5
Reboots the ATLAS
_ 800. When you select this command, the following
message displays: ** WARNING ** This will reboot the entire system!
Press y to reboot the system, or n to exit the command.
» Factory Default
System
Write security: 0; Read security: 0
Resets the entire system to the factory default settings. To reset the system,
press
y ; to cancel this command, press n .