ADTRAN ATLAS 800 Series Module QUAD E1, User Manual, Page: 102 / 190

Chapter 9. Dial Plan Terminal Menu
9-8 ATLAS 800 User Manual 61200180L1-1
» Nbr Complete
Templates
Write security: 1; Read security: 5
Defines to ATLAS when a phone number is complete. For any outgoing
call, ATLAS must be able to recognize when the phone number is complete.
For example, a local number will be seven digits long while a long distance
(1+ #) will be 11 digits long. The ATLAS defaults will cover almost any
installation, and these templates should not require any additional user
input except for unusual circumstances. The template allows the use of
“wild card” inputs to define numbers:
» Number Type
Templates
Write security: 1; Read security: 5
Defines to ATLAS the number type. ISDN interfaces require that a number
type be sent over the D channel when a call is sent or received. A normal
RBS trunk does not send a type designator, but uses prefixes instead. For
example, “1 +” prefix is national long distance call type while a “011 +” pre-
fix would be an international long distance call type. These templates form
a table to permit ATLAS to translate the RBS prefix into a call type for ISDN
and vice- versa.
X = Any single digit
N = Any single digit 2—9
911 = This specific number
[1,2,3...] = A single digit in this group
# Denotes an Entry Number (MAX 50). Press INS/DEL to in-
sert/delete any entry.
Pattern Modifies an entry when you press Enter (MAX 40).
For example, 1+(NXX) NXX - XXXX would be a pattern for a
normal long distance call. Note that the symbols ( ), +, - and
space are not required and are only used to improve read-
ability.
The ATLAS default templates should cover all applications and
should not need to be added to by the user except for very rare
circumstances.
# Denotes an Entry Number (MAX 50). Press INS/DEL to in-
sert/delete any entry.
Prefix Sets the prefix for the number type. Only digits 0 and 1 are
allowed (MAX 6).
Pattern Modifies an entry when you press Enter (MAX 40).
Number Typ Lists valid selections when you press Enter .