ADTRAN ATLAS 800 Series Module QUAD E1, User Manual, Page: 76 / 190

Chapter 6. Terminal Menu and System Control
6-16 ATLAS 800 User Manual 61200180L1-1
»» Load and Use
Config
Write security: 3; Read security: 5
Retrieves the configuration file specified in the
TFTP Server Filename
field from the server. To start this command, enter Y to begin or enter N to
cancel.
»» Save Config
Remotely
Write security: 3; Read security: 5
Saves the configuration file specified in
TFTP Server Filename to the
server identified in TFTP Server IP Address . To start this command, enter
Y to begin or enter N to cancel.
» System Utilization
Write security: 0; Read security: 0
Displays statistics related to the internal operating system of the ATLAS.
Please check with Tech Support before attempting to use this feature.
» System Selftest
Write security: 3; Read security: 5
Initiates a system self-test consisting of memory tests and data integrity
tests for each installed module.
»» Selftest Run
Write security: 3; Read security: 5
Activates the self-test. To confirm self-test activation, press
y
; to cancel the
self-test press
n
.
»» Status
Write security: 3; Read security 5
Indicates a system self-test. The self-test consists of memory tests and data
integrity tests for each installed module.
»» View Selftest Log
Read security: 5
Displays time-stamped log of the tests conducted and the Pass/Fail results.
Self-tests verify data integrity and processor control to each port. Each port
is looped back and a data pattern is sent and tested. The result of the self-
test on each installed port is listed with Pass/Fail results. A typical test log
is shown in Figure 6-5. The log includes the following additional fields.
If you execute this command, the ATLAS _ 800 retrieves the
configuration file, reboots, then restarts using the new configuration.
Before using this command, you must have identified a valid TFTP
server in
TFTP Server IP Address .
Self-tests disrupt data flow.
Idx Index number of the log
Time
Time and date log created