ADTRAN ATLAS 800 Series Module QUAD E1, User Manual, Page: 109 / 190

Chapter 9. Dial Plan Terminal Menu
61200180L1-1 ATLAS 800 User Manual 9-15
• Default value = 0. The default ID for all end points is 0 and for all
Accept # s is 0. With default values, all calls are routed based only on
the dialed number.
• Multiple end points can have the same Source ID .
• When creating the call accept list, specify a Source ID as well as a dialed
number or range of dialed numbers to accept.
Say, for example, that an application requires all calls originating from
Port 1 of the T1/PRI module in Slot 1 be switched to Port 4 of that same mod-
ule. You would assign a unique
Source ID (e.g., 7) to Port 1 of the module,
and then configure Port 4 to only accept calls from that unique Source ID (7).
User Termination/PRI
Figure 9-5 shows the available interface configuration options when you are
working in
User Term , Slot is defined as a T1/PRI module, and Sig is set to
PRI .
Figure 9-5. User Term PRI / Ifce Config Menu Tree
»» Switch Type Write security: 3; Read security: 5
Defines the type of PRI switch that ATLAS will emulate. If connected to
another ATLAS, both need to be set to the same switch type (
Lucent 5E or
AT&T 4ESS ).
»» First DS0 Defines the first active DS0 for a fractional PRI.
»» Number of DS0s Write security: 3; Read security: 5
Defines the number of DS0s used for calls on a fractional PRI. DS0 24 is
assumed to be used by the PRI for the D channel.
Lucent 5E
Switch Type AT&T 4ESS
First DS0
Number of DS0s
Strip MSD
Netwrk Spec. Fac.- Voice
Netwrk Spec. Fac.- Data None
Called Digits Transferred Three
IfceConfig Four
All
Outgoing Caller ID Send as Provided
Substitute if not present ID Presentation
ID Number
Source ID Substitute Always ID Presentation
Swap ANI/DNIS ID Number