ADTRAN ATLAS 800 Series Module QUAD E1, User Manual, Page: 38 / 190

Chapter 3. Operating the ATLAS 800
3-2 ATLAS 800 User Manual 61200180L1-1
Figure 3-2. Example of Basic Front Panel Menu Navigation
USING THE TERMINAL MENU
The terminal menu provides a primary means of monitoring and configur-
ing the ATLAS
_ 800. The terminal menu interface uses the full capabilities of
the VT-100 terminal to provide the quickest and most intuitive operation
possible. To receive the full benefit of the terminal menu interface, you
should use a fully VT-100 compatible client. The ADTRAN Utilities floppy
disks contain both a VT-100 client and a customized Telnet program (install
these on a PC). See ADTRAN Utilities on page 12-1 for details on the avail-
able programs. You can access the terminal menu using a VT-100 terminal
or a computer running VT-100 terminal-emulation software.
The two basic connection methods supported by the ATLAS _ 800 are a Tel-
net session and a direct connection through the EIA-232 Chain In port. The
following sections describe using both of these methods.
1) ETHERNET 1) BAUD RT 9600
S0) SYSTEM 2) FLOW CTL
2) CONFIG S1) 2) CHAIN PORT 3) TYPE
: 4) UNIT ID
S8) 5) INIT MODEM
Setting Up the Unit ID using the Front Panel Menu, CONFIG
Step Action
1
Activate CONFIG by pressing the Front Panel arrow keys or by
pressing the number 2 on the Front Panel. (The cursor flashes on
the number next to the activated selection.) Press Enter on the
Front Panel.
2
Use the Front Panel Arrow Keys to view the submenu items.
3 Select S0) System. Press Enter on the Front Panel.
4
Activate 2) Chain Port using the
Arrow Keys
or by pressing
2
.
Press
Enter on the Front Panel.
5
Activate 4) Unit Id using the Arrow Keys or by pressing 4 . Press
Enter on the Front Panel.
6
The
Unit Id
field displays. Type the new Unit ID in this field and
press Enter on the Front Panel. The new Unit ID is now set.