2
Press <Enter>.
3
When prompted for a username, enter adtec.
4
When prompted for a password, enter none.
Once the prompt "User 'adtec' connected" is seen, the session is open and API commands
are ready to be entered.
Microsoft Windows 7 and higher may have telnet disabled by default. An operator may
enable telnet or they may download a third party program. PuTTY is a popular API program
that offers both network and serial control options. To enable the default telnet client
installed on Windows 7 or higher:
Step Action
1
Click on Start -> Control Panel
2
Click on the Programs category
3
Click ‘Turn Windows features on or off’ under the ‘Programs and Features’
catgegory
4
Place a check mark inside of ‘Telnet Client’ and click OK
5
Please be patient as Windows enables Telnet capability, it can take several
minutes.
SNMP Interface
The SNMP or Simple Network Management Protocol interface is an advanced interface to
interact with Adtec products. This interface is available for special cases such as system
integration, network management systems (NMS) and developers. Third party software is
usually written around this interface so users may interact with the product. An operator
does not generally interface with SNMP directly, but instead will interface with third party
software.
SNMP MIB’s (Management Information Base) that describe the interface can be found on
each product’s Web interface under the Help tab.
RD Web UI Authentication and Security Features
Summary
77
Summary of Contents for RD-71
