entered.
Address
-
TCP/Zixi-Link Mode:
If using TCP or ZIXI-Link, point to point modes, a value
of 0.0.0.0 (listening) should be entered. Stream management / transmission is done
through the transmitter or Adtec encoder.
Address
-
Zixi Rx Mode:
In Zixi Rx mode, the IRD acts as a subscribing client. This
address should contain the desired IP address of a Zixi Broadcaster.
Port
-
Multicast Port is the number to be used for multicast/unicast streams. Set in
conjunction with Multicast IPA. Range is 0 to 65535. If the port number is set to 0, then no
UDP/RTP streams will be received. 0 is default.
Source Address
-
Configures the multicast receive Source Specific IP Address. This
configuration should be configured to 0.0.0.0 (any source multicast) in most IGMPv2
multicast applications. This configuration is an advanced configuration used for redundancy,
security, or IGMPv3 multicast applications. It does not function for Unicast, TCP or Zixi
reception.
Latency
-
Multicast Latency sets the latency delay before the decoder begins playback from
the multicast source and should be argued as a millisecond value. The default
MULTICASTLATENCY setting is 500 milliseconds.
The maximum configurable range of the MULTICASTLATENCY is dependent upon bit rate
(10MB buffer) with the floor configurable for 4ms. The accuracy of the actual latency
compared to the configured latency is dependent upon the bit-rate and protocol used. The
RD adjusts the IP reception rate to match the configured multicast latency setting and is
more accurate in UDP/RTP reception.
Timeout
-
Sets the timeout value for return to normal video playback after video multicast
packets are no longer detected. The default timeout value is 300 milliseconds. If the timeout
value is set too low, the multicast receive may timeout during normal reception if the packet
transmission is bursty.
Error Recover - Multicast Error Recovery sets the timeout value for recovery of multicast
receive after decoder error condition is detected.
The default error recovery timeout is configuration value is 10000 milliseconds.
IP Statistics
shows advanced statistics about the received stream. IP Rx Uptime, Buffer
Size and DVB Per IP statistics are shown for all IP streams (UDP, RTP or TCP). The second
half of IP statistics will only populate if an RTP stream is being received. If an RTP w/
SMPTE 2022 FEC stream is detected, FEC statistics will populate.
IP Params - ZIXI Rx Mode
Channel name
is the name of the channel that is desired to be streamed. This should
correspond to the Broadcaster 'Stream ID'.
53
Summary of Contents for RD-71
