Rack Installation
The RD-71 is intended to be mounted in a standard 19” rack. It occupies 1RU of rack space
and the connections are all on the rear of the unit.
To install the RD-71 into a rack use the following steps:
Step
Description
1
Determine the desired position in the rack for the RD-71 making sure that the
air intake and exhausts on the sides of the unit will not be obstructed.
2
Insert the rack mount clips into place over the mounting holes in the rack.
3
Slide the RD-71 into position in the rack.
4
Secure the RD-71 to the rack by installing four rack screws through the front
mounting holes and tightening.
5
If needed, secure a grounding wire use the grounding location on the rear
panel of the RD-71.
Back Panel
Connector
Description
Processor
Power 1 & 2
Redundant AC Power, Standard 3 pin computer power plug
(Auto range 70-240 VAC Input)
COM2
API Serial Communication Interface
COM1
Serial Port Used for Troubleshooting (Terminal)
IP 1
Default Management/Monitoring interface (10/100/1000)
IP 2
Default UDP/RTP transport interface (10/100/1000)
7
Summary of Contents for RD-71
