Audio #
PID
-
Sets the PID for the given audio decoder. You can select one option from the list
provided, or enter it manually. If entering the PID value manually, use decimal format.
Valid ranges (inclusive):
32 - 8191
Valid Decimal range
0
Used to disable the audio decoder
65535
Used to set the DEFAULT PID (First Found).
NOTE:
No more than four passthru PID's are supported at this time. Hexadecimal values
may be entered when in manual mode, but must be prepended with 0x. IE. '0x157E' and
'5502'' are both valid manual entries.
Offset
-
Adjust the audio sync offset for a given pair index with a millisecond offset value.
Volume
-
Adjusts the value of the analog volume in dB increments. The volume will
attenuate, amplify or mute the audio. The valid range is -40 db to +18 dBu in ANALOG
mode.
Dolby Digital Mode
-
Sets the Dolby Digital AC3 Output format.
--
Invalid Output Format
0 - PASSTHRU
[compressed] (default)
2 - DECODE
STEREO
[2/0]
NOTE
: If not set to PASSTHRU and the output mode does not equal the bitstream audio
coding mode (acmod), then the decoder will perform downmixing or fill channels with zero
values to meet the desired output configuration.
Dolby E Line
-
This is used to configure Dolby E placement in the SDI output and is
configurable per audio engine. When set to AUTO (-1), the default configuration, the Dolby
E line is placed within the valid line number range for the video resolution. The Dolby E line
may be manually configured to a value within range. Valid ranges for Dolby E line
placement are resolution and frame rate dependent. If the configured value is not valid, the
system will use the valid line used by the 'AUTO' mode as per the
Dolby table
. The Dolby E
line status information (in status panel) can be used to see the actual Dolby E line
placement.
SDI Audio Matrix
allows any of the eight pairs of audio originating from the decoder to be
routed to any of the eight audio outputs on the SDI interface. The matrix also allows the
placement of Passthru audio on any of the 8 SDI output pairs. This enables the
customization of the audio channel mappings from their default configuration.
64
Summary of Contents for RD-71
