Adtec RD-71, User Manual

Page: 19 / 118

S2X Rolloff S2X Rolloff will allow the tuner to operate in an
optimized mode for roll-offs of 15% or less.
When disabled, it will operate in standard 20% -
35% as defined by the incoming S2 BBHeader.
Due to modulation manufacturers providing
backwards compatibility during S2 to S2X
migration, this must be manually configured for
the best 5%, 10% and 15% roll-off
performance.
DISABLED
ENABLED
LNB Polarity This control is primarily used in “Universal” LNB
applications. The LNB Polarity control allows for
LNB polarization selection; the 13VDC source will
select the Vertical polarity and the 18VDC source
will select the horizontal polarity. For typical “C”
and “Ku” band applications, the 18 VDC option is
recommended.
OFF
H(18V)
V(13V)
LNB Tone This control is used only for Universal LNB
applications. A universal LNB can route the high
or low band from either polarity to the IRD. The
high band is selected by enabling the 22 kHz
tone and the low band is selected when the 0 Hz
tone is enabled.
0KHz
22KHz
Modulation
Type Allows the selection of the mod type. AUTO
DVBS
DVBS-2
Symbol
Rate
The number of symbols transmitted per second.
The amount of data per symbol is dependant
upon the modulation type, e.g. QPSK, 8PSK, etc.
Set this field to 0 for automatic Symbol Rate.
0 = AUTO
maximum value is determined by
feature key.
ISI ISI (input stream identifier) is required for
multistream applications. If a multistream RF
source is detected, BBHeaders containing this
value will be demodulated and output to the
receiver. This value has no effect during single
stream applications.
0 - 255
RF Stats
Menu
RF Stats General RF Lock Status is provided via the RF
quickview menu, but a detailed list of further
information can be found in this menu.
19