ADT Commercial Fire & Burglary Alarm System FOCUS 200 PLUS, Installation And Setup Manual

Page: 52 / 216

FOCUS 200 PLUS Installation and Setup Guide
5-24
RF Gateway Physical Description
The gateway consists of a printed wiring board that is installed in a plastic housing unit. The following
are important items on the board (see Figure 5-16):
Part Purpose
Terminal Strip TB1 Used for making connections to the RS-485 bus, to the RF receiver, and to
power the RF gateway.
Panel LED (red) Indicates the following status:
Steady OFF: No communication/activity between the control panel and the
RF gateway.
Flashing: Normal condition.
Steady ON: The RF gateway is in an error state.
RF LED (green) Indicates the following status:
Steady OFF:
The RF gateway is in an error state or is receiving no power.
Flashing: Normal condition.
Steady ON: Power indication for the RF gateway. No RF transmission
activity, or receiver(s) have failed, or the receiver’s antenna has
a problem.
6
5
4
3
2
1
( +) 12V
(–) GND
H BUS (+)
H BUS (–)
DATA INPUT
DATA OUTPUT
5800ADT RF EXPANDER MODULE
PANEL LED (RED)
RF LED (GREEN)
5800ADT
TB1
I
O
+
+
–
–
6
5
4
3
2
1
( +) 12V
(+)
12V
(–) GND
(–)
GND
H BUS (+)
(+)
H BUS (–)
(–)
DATA INPUT
DATA OUTPUT
CONNECT TO
5881H/5881EH/5882H
RF RECEIVER
TO
CONTROL PANEL
G
R
E
E
N B
L
A
C
K Y
E
L
L
O
W
R
E
D
TB1
I
O
+
+
–
–
5800ADT
TERMINALS
P1
ECP
BUS
RS485
BUS BLA
CK
YELLO
W
BLUE
RED
CONNECTOR
Figure 5-16: RF Gateway Wiring Connections
Installing the RF Gateway
Mounting the RF Gateway
To mount the RF gateway, perform the following steps:
Step Action
1 Remove the RF gateway’s circuit board from its plastic case and mount the case with the
appropriate mounting hardware.
2 Re-insert the circuit board into the plastic case.