ADEMCO VistaKey-SK, Installation & Setup Manual

Page: 90 / 108

VistaKey Installation Guide
6–16
Quit?
1=YES 0=NO
0
Press 1 or 0.
If you press 1, the system advances to the “Quit Card Mode?”
prompt.
If you press 0, the system returns to the “Swipe Card” prompt.
Press [
✲
] to accept the entry.
Block Delete
Block Delete?
1=Yes 0=No
0
Press 1 or 0.
If you press 1, the system advances to the next prompt.
If you press 0, the system advances to the “Manual Delete?” prompt.
Delete from Card
1-250 0=Quit
001
Enter the 3-digit number corresponding to the beginning (lowest)
card number for the deletion. If you enter 000, the system advances
to the “Quit Card Mode?” prompt.
Press [
✲
] to accept the entry.
To Card
1-250 0=Quit
000
Enter the 3-digit number corresponding to the ending (highest) card
number for the deletion.
NOTE: If this number is not greater than the number entered as the
“Delete from Card” above, no cards will be deleted.
Press [
✲
] to accept the entry.
Are you sure?
1=Yes 0=No
0
Press 1 or 0.
If you press 1, the system marks the card database that these card
numbers are deleted from the card database and returns to the
“Delete from Card” prompt.
If you press 0, the system returns to the “Delete from Card” prompt
without marking any cards in the database for deletion.
Press [
✲
] to accept the entry.
Manual Delete
MANUAL Delete?
1=YES 0=NO
0
Press 1 or 0.
If you press 1, the system advances to the next prompt.
If you press 0, the system advances to “Quit Card Mode?” prompt.
Delete Card ID#
(001-250) 0=Quit
0
Enter a number from 001 to 250 or 000 to quit.
If you entered a number from 001 to 250, the system advances to
the next prompt.
If you entered 000, the system advances to the “Quit Card Mode?”
prompt.
Press [
✲
] to accept the entry.
Are you sure?
1=Yes 0=No
Press 1 or 0.
If you press 1, the system marks the card database that the card is
deleted and the system returns to the “Delete Card ID#” prompt.