ADEMCO VistaKey-SK, Installation & Setup Manual

Page: 89 / 108

Section 6 – User Commands
6–15
•
Action codes 60 (AP Exit Only), 66 (AP Group Exit Only), or 72
(AP Partition Exit Only) disable the entry reader at the access
point. The reader will remain disabled until a command is
received (via a keypad command or event) to protect the access
point.
Press [
✲
] to accept the entry.
In response to the action entered, the system displays a message
asking for additional information based on the action you selected.
For example, if the action you selected was 01 (relay on), the system
presents a message asking for a relay number. Respond to the
message displayed, and then press [
✲
] to accept the entry.
Quit?
1=YES 0=NO
0
Press 1 or 0.
If you press 1, the system advances to the “Quit Card Mode?”
prompt.
If you press 0, the system returns to the “Exec Priv?” prompt.
Auto Delete
Auto Delete?
1=Yes 0=No
0
Press 1 or 0.
If you press 1, the system advances to the next prompt.
If you press 0, the system advances to “Block Delete?” prompt.
SWIPE CARD
xxx-xx-xxxxxxx
Swipe card or enter card number to be deleted. The card number
and VISTA card ID number to be deleted aredisplayed on the
keypad. Note that if the card swiped is not found in the system
database, the card number displayed and VISTA card ID number
are shown as zeros.
Press [
✲
] to accept the entry.
If the card is found in the system database, the system advances to
the “Are You Sure?” prompt.
If the card is not found in the system, the following “Card not Found”
prompt is displayed.
Card not Found
✲
to continue
Press [
✲
] to continue. The system advances
to the “Quit?” prompt.
Are You Sure?
1=YES 0=NO
0
Press 1 or 0.
If you press 1, the system marks the card database that the card is
deleted.
If you press 0, the system advances to the “Quit?” prompt.
Press [
✲
] to accept the entry.