ADEMCO VistaKey-SK, Installation & Setup Manual

Page: 31 / 108

4–1
S E C T I O N 4
Detailed Installation
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
♦
General Information
♦
Installing the Equipment
♦
Mapping VistaKey Zones for Test
♦
Initial System Test
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
This section provides detailed procedures for mounting and connecting the VistaKey-SK or
VistaKey module and related devices. The procedures are for one access point, and should be
repeated for each additional access point being installed. Figure 4-1 illustrates what a typical
installation looks like. The installation categories described in this section are: Installing the
Equipment, Mapping VistaKey Zones for Test, and Initial System Test.
If you have performed the procedures in
Section 3 – Quick Installation
, bypass this section and
proceed to Section 5 – Programming .
INSTALLING THE
EQUIPMENT
MAPPING VISTAKEY
ZONES FOR TEST
INITIAL SYSTEM TEST
Installing the Equipment
To mount and connect the hardware required to create an access point, perform the steps
provided in the following paragraphs.
Entry
Reader
Door Strike
Request
To Exit
Door Status
Monitor
OUTSIDE PROTECTED AREA INSIDE PROTECTED AREA
VistaKey
Figure 4-1: Typical VistaKey Installation