USER MANUAL
BEAT HF
Edition: January 2016
Revision: No. 4
MODE OF USE -
23
3.3.4 Entering the additional data: only if enabled
After identifying the operator and the job, or not, or if disabled, the following screen will
appear when the unit is turned on:
If an identity of additional data has been entered previously:
Initial screen:
Next screen:
dd/mm/yy
hh:mm
Additional data
ABCDEFGHIJKLMNOP
Confirm
Press either the or
arrow once to select the
Erase screen.
dd/mm/yy
hh:mm
Additional data
ABCDEFGHIJKLMNOP
Erase
Press <START> to accept and go to the next screen or select Erase if the identity of the
additional data needs to be altered.
If the identity of the additional data has not been previously entered or erased:
Initial screen
Ø
:
Next screen
Ù
:
Final screen
Ú
:
dd/mm/yy
hh:mm
Additional data
----------------
Read barcode
dd/mm/yy
hh:mm
Additional data
----------------
Manual edition
dd/mm/yy
hh:mm
Additional data
----------------
Skip over
Ø
On the initial Read barcode screen, the unit remains on hold while the additional data
is read using an optic pen or scanner. When the identity is entered:
dd/mm/yy
hh:mm
Additional data
ABCDEFGHIJKLMNOP
Confirm
Code 128 up to 16 characters. The additional data
decoding is shown.
If the barcode or reading were erroneous.
dd/mm/yy
hh:mm
Additional data
----------------
Wrong data
If the barcode is entered incorrectly, the unit emits two
acoustic signals and a Wrong data message appears
on the screen. Press either <STOP> or <START> to go
to the Read barcode screen and repeat the proce-
dure.
Once the correct identity has been correctly read, press <START> to accept and go to the
next screen.
