ACTEON Equipment SATELEC Implant Center, User Manual

Page: 10 / 156

Footswitch:
Length: 177mm
Width: 173mm
Height: 43mm
Weight: Max. 700g
LCD screen:
Height: 86mm
Width: 115mm
Micro-motor cord: 2,000mm
Scaler handpiece cord: 2,000mm
I-S
URGE
micro-motor:
Length: 99mm
Diameter: 21mm
Weight: 120g
Coupling type: According to standard ISO 3964
Temperatures:
Operating: + 10°C to + 40°C
Storage: - 20°C to + 70°C
Humidity:
Operating: 30% to 75%
Storage: 10% to 100% including condensation
IV - INSTALLATION / FIRST
USE
4. 1 UNPACKING THE DEVICE
Upon reception of the device, check for any
damage caused in transit.
Contact your supplier if necessary.
4. 2 RECOMMENDATIONS
Have your I
MPLANT
C
ENTER
connected to the power
electricity supply by a certified dental
installation technician.
The electrical connection of the I
MPLANT
C
ENTER
must comply with the applicable standards in
your country.
A grounded power supply socket must be used.
4. 3 INSTALLATION
Important:
Do not place the I
MPLANT
C
ENTER
close to or on
top of another device.
Do not place the power cord and the footswitch
cord in a wire cover or in a cable gland.
- Place the control unit in position on a fixed
surface, horizontal or with a slope of no more
than 5°.
- Check that the power switch (Fig. 2-5) is in
position O (off).
- Connect the power cord to the receptacle of
the device.
- Connect the power cord to a socket with a
ground pin.
- Connect the control footswitch to the
footswitch connector (Fig. 2-2).
- Position the footswitch so that it is easily
accessible for your feet.
- Insert the brackets into the bracket holders
(Fig. 2-4).
- Connect the micro-motor cord to the connector
(Fig. 1-8).
- Align the I-S
URGE
micro-motor and cord
connector electrical contacts, then screw the
motor onto the connector.
- Connect the N
EWTRON
scaler cord or the P
IEZOTOME
handpiece cord to the connector (Fig. 1-10)
(according to option).
- Connect the N
EWTRON
handpiece to the scaler
cord (delivered according to option).
- Place the I-S
URGE
micro-motor on its rest.
10