ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
11
9
5. Setting up the device
User code (4-digit number-combination, free available),
U.CodE
:
Default:
0000
If this code was set (>0000), all parameters are locked for the user, if
LOC
has been selected
before under menu item
run
. By pressing
[P]
for 3 seconds in operation mode, the display
shows
COde
. The
U.Code
needs to be entered to get to the reduced number of parameter sets.
The code has to be entered befor each parametrisation, until the
A.Code
(Master code) unlocks
all parameters again.
The same applies to
LI-2
!
Function for threshold value undercut /exceedance,
Fu-1:
Default:
high
A limit value undercut is selected with
Louu
(for LOW = lower limit value), a limit value
exceedance with
High
(for HIGH = higher limit value). If e.g. limit value 1 is on a threshold level
of 100 and allocated with function
High
, an alarm is activated by reaching of the threshold level.
If the threshold value was allocated to
Low,
an alarm will be activated by undercutting the
threshold value, as long as the hysteresis is zero.
Master code (4-digit number-combination, free available),
A.CodE
:
Default:
1234
All parameters can be unlocked with this code, after
LOC
has been activated under menu item
run
. By pressing
[P]
for 3 seconds in operation mode, the display shows
COde
and enables the
user to reach all parametes by entering the
A.codE
. Under
run
the parameteisation can be
activated permanently by selecting
ULOC
or
ProF
, thus at an anew pushing of
[P]
in operation
mode, the code needs not to be entered again.
Hysteresis for limit values,
HY-1:
Default:
00000
The delayed reaction of the alarm is the difference to the threshold value, which is defined by
the hysteresis.
Parameterisation level
Menu level
