ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
9
7
5.1. Switching on
Once the installation is complete, start the device by applying the voltage supply. Before, check once again
that all electrical connections are correct.
Starting sequence
For 1 second during the switching-on process, the segment test (
8 8 8 8 8
) is displayed followed by an
indication of the software type and, after that, also for 1 second the software version. After the starting
sequence, the device switches to operation/display mode.
5.2. Standard parameterisation:
(Flat operation level)
To parameterise the display, press the
[P]
-key in operating mode for 1 second. The display then changes to
the menu level with the first menu item
TYPE
.
5. Setting up the device
5. Setting up the device
Setting the end value of the measuring range,
END
:
Default:
10000
Set the end value from the smallest to the highest digit with
[
▲
] [
▼
]
and confirm each digit with
[P]
. A minus sign can only be parameterized on the highest value digit. After the last digit, the
display switches back to the menu level. If a sensor calibration was selected as input option,
you can only select between
noca
and
cal.
With
noca
, only the previously set display value is
taken over, and with
cal
, the device takes over both the display value and the analogue input
value.
Setting the start/offset value of the measuring range,
offs
:
Default:
0
Enter the start/offset value from the smallest to the highest digit with
[
▲
] [
▼
]
and confirm each
digit with
[P]
. After the last digit the display switches back to the menu level. If a sensor
calibration was selected as input option, you can only select between
noca
and
cal.
With
noca
,
only the previously set display value is taken over, and with
cal
, the device takes over both the
display value and the analogue input value.
Selection of the input signal,
tYPE:
Default:
s.60ou
Available as measuring input options are 0-600/0-300 VAC or 0-5/0-1 AAC signals as works
calibration (without application of the sensor signal) and
S.600v, S.300v, se.5a
and
se.1a
as sensor
calibration (with the sensor applied). Select with
[
▲
] [
▼
]
and confirm the selection with
[P]
.
Parameterisation level
Menu level
