ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
15
5. Setting up the device
13
Device undercut,
dI.Und:
Default:
-i9999
With this function the device undercut (
_ _ _ _ _
) can be defined on a definite value.
Analog values for setpoints,
InP.01 … InP.30:
The setpoints are always preset according to the selected input signal A/V. The desired analog
values can be freely parameterised in ascending order.
Display values for setpoints,
dIS.01 … dIS.30:
Under this parameter setpoints are defined according to their value. At the sensor calibration,
like at final value/offset, one is asked at the end if a calibration shall be activated.
Number of additional setpoints,
SPCt:
Default:
00
30 additional setpoints can be defined to the initial value and final value, so linear sensor
values are not linearised. Only activated setpoint parameters are displayed.
Setting up the physical unit,
UnIt:
Default:
no
One can choose between the above shown physical units. It will be displayed on the 5th digit of
the display.
Parameterisation level
Menu level
