Acer Altos RAIDWatch, Manual

Page: 168 / 212

Altos RAIDWatch User Guide
154
• Sender’s E-mail: enter the valid e-mail address that will be used as the “From” part of event e-
mail notices.
• Receiver’s E-mail: enter the full internet e-mail address for the receiver.
• Subject: enter a subject for notification e-mails. Currently, Subject is not available for Unix-
based platforms.
• Message: enter the message to be included as the e-mail event notices. Messages can be added
such as the contact information of technical personnel.
When you have finished, click Add to have NPC send event notification e-mail messages to this e-
mail address. Next, either enter another e-mail address to receive notices, choose another NPC item
to configure, or click Close to save changes and exit the installation procedure.
11.9 Configuring SNMP Trap Notification
Starting SNMP trap receiving capability can be as simple as keying "net start snmp" and "snmputil
trap"
at the DOS prompt under Windows-based systems.
To enable SNMP receiving capability under Linux, you can use the
"snmptrapd -P"
command.
SNMP trap notification is a supported NPC function. Simply enter the IP addresses of SNMP agents
for trap notification to work.
Avail hosts to be listening to SNMP traps by entering its IP addresses and adding the addresses to
the list of trap receivers.
Users may select a severity parameter (1,2, or 3). The parameter determines events of what severity
level(s) are to be sent via SNMP.
Figure 11–7 : SNMP Trap List
1 All severity levels