Acer Altos RAIDWatch, Manual

Page: 166 / 212

Altos RAIDWatch User Guide
152
• Initializing String: is a standard AT command set initialization command string. The default is
&F1X0M0 and should be appropriate for most modems. If you need to change it, consult your
modem manual for the correct AT command string.
The Initializing String is applied for fax and pager service on Unix-based systems.
When you have finished, click Add to have NPC send event notifications to this fax machine. Next,
either enter another fax machine to receive notices, choose another NPC item to configure, or click
Close to save changes and exit the installation procedure.
11.6 Configuring Pager Notification
Pager notifications, like faxes, are sent using the fax/modem, so an NPC modem configuration is
required.
NPC allows you to set a telephone number for the receiving pager, the message that will be sent to
the pager, the modem that will be used from a list of available modems, and the initialization string
the NPC will use when starting to send a pager message.
• Telephone: enter the phone number of the event notification receiving pager. Note that you
must enter the entire dialing sequence (no hyphens) including line access, country and area
codes.
• Message: the message that will be delivered to the pager.
• Available Modems: choose a modem from those listed in the drop box.
• Initializing String: is a standard AT command set initialization command string for Unix-based
systems. The default is:
V1B1E0F0L1M1Q0TV1X1Y0&C1&D2&G0S7=20
and should be appropriate for most modems sending to a pager. If you need to change it,
consult your modem manual for the correct AT command string.
When you have finished, click Add to have NPC send event notifications to this pager. Next, either
enter another pager to receive notices, choose another NPC item to configure, or click Close to save
changes and exit the installation procedure.
11.7 Configuring Broadcast Message
Notification
Broadcast messages are sent to every station on the subnetwork configured. A broadcast message
should cause a window to appear that will stay visible until manually closed by a user.
To enable Message Broadcast in Solaris, open a console terminal and then execute "./
rpc.rwalld"
under "/usr/lib/netsvc/rwall".