50
10.7.13. Jamming Detection
Use the control buttons
to select
Jamming Detection
.
Confirm your selection by pressing the control button
under the
word
Select
. To cancel input, press the control button
under the
word
Back
.
If you confirm
Jamming Detection
with the
Select
button, you see the
following graphic display:
Use the control buttons
to select whether the alarm system is to
display a warning in the case of jamming detection. If this function is
enabled, a warning is issued on the display if jamming is detected. To
select a function, press the control button
under the word
Select
.
To cancel input, press the control button
under the word
Back.
10.7.14. Batt Load Test
Use the control buttons
to select
Batt Load Test
.
Confirm your
selection by pressing the control button
under the word
Select
. To
cancel input, press the control button
under the word
Back
.
If you confirm
Batt Load Test
with the
Select
button, you see the
following graphic display:
Use the control buttons
to select whether the alarm system is to
test the battery capacity at every disarming or every 23 hours. If the
function is disabled, the system tests other less important functions
every hour. To select a function, press the control button
under
the word
Select
.
To cancel input, press the control button
under
the word
Back.
To select a function, press the control button
under the word
Select
.
To cancel input, press the control button
under the word
Back.
(If the radio alarm panel is communicating or playing/recording
speech then the radio alarm panel will delay the test until those
activities are finished.)
If mains power is absent then the radio alarm panel carries out the test
as soon as mains power is restored.
