Preparing and fixing the wallbox in place |
29
Preparing and fixing the wallbox in place
Continue to prepare the wallbox:
1
Unlock both the side RCCB flaps using the key sup-
plied and flip them up to unlock the housing cover.
2
Grasp the upper edge of the housing cover with
your fingertips and open the housing cover to the
front.
NOTE
Removing the housing cover
To make installation easier, you can remove the housing cover mechanically from the wallbox. This procedure is
described in the section "Replacing the housing cover" on page 56.
3
Feed the power line and, if necessary, the data
cable into the wallbox through the corresponding
grommets in the supply cable area.
4
If you want to integrate the wallbox into a LAN
network via a data cable, form a cable loop and
enclose it with the folding ferrite before inserting it
into the wallbox through the corresponding grom-
met in the supply cable area.
5
Lay the loop of the data cable on the rear of the
wallbox and hang the wallbox in the two tongues
of the mounting rail using the suspension points on
the back.