Pannoramic MIDI II 2.0.5 User’s Guide
7 Troubleshooting and Maintenance
7.3 Maintenance
This section describes the most common maintenance solutions that can be performed by the user of
the product. For maintenance solutions not described in this manual, contact the service personnel.
7.3.1 Opening the protective covers
To perform any maintenance work and to interrupt a running digitization procedure because of slide
or tray jamming, the protective covers of the Pannoramic MIDI II need to be opened in order to
eliminate the problem.
Before removing the cover, exit the control software, switch off the 24 V power supply and
disconnect the power cables (exception: filter change).
Note:
To improve access to special points you can remove the covers
completely.
Figure 79 – Removal of covers
The protective cover is composed of two halves locked to each other. Locate the hole
(1)
at the front
of the right half of the cover
(2)
:
1. Push with a blunt or long object (for example, with a 3 mm Allan key) against the opener
lever behind the hole to open the lock. You will hear a “clack”.
December 7, 2018 - Rev. 1
3DHISTECH Ltd.
128
(
144
)