3Com VCX V7111, User Manual

Page: 434 / 464

434
3Com
®
VCX V7111 VoIP Gateway User Guide
About the Call Progress Tones Wizard
The Call Progress Tones wizard helps detect the Call Progress Tones generated by your
PBX (or telephone exchange) and creates a basic Call Progress Tones
ini file (containing
definitions for all relevant Call Progress Tones), providing a good starting point when
configuring an V7111/FXO gateway. This
ini file can then be converted to a dat file that can
be loaded to the gateway using the TrunkPack Downloadable Conversion utility.
To use this wizard, a V7111/FXO gateway connected to your PBX with two physical phone
lines is required. This gateway must be configured with factory-default settings and should
not be used for phone calls during the operation of the wizard.
Note that firmware version 4.2 and above is required on the gateway.
Installation
The CPTWizard can be installed on any Windows 2000 or Windows XP based PC.
Windows-compliant networking and audio peripherals are required for full functionality.
To install the CPTWizard, copy the files from the supplied installation kit to any folder on your
PC. No further setup is required (approximately 5 MB of hard disk space are required).
Initial Settings
To start the CPTWizard:
1
Execute the CPTWizard.exe file; the wizard’s initial settings screen is displayed.
Figure 155
Initial Settings Screen
2
Enter the IP address of the V7111/FXO gateway you are using.
3
Select the gateways ports that are connected to your PBX, and specify the phone
number of each extension.