ZyXEL Communications OLT2406, Руководство пользователя

Страница: 331 / 766

Chapter 41 RIP
OLT2406 User’s Guide
331
41.2 Configuring RIP
Click IP Application > RIP in the navigation panel to display the screen as shown. You cannot manually
configure a new entry. Each entry in the table is automatically created when you configure a new IP
domain in the
IP Setup screen (refer to Section 8.6 on page 102 ).
Figure 202 IP Application > RIP
The following table describes the labels in this screen.
Table 151 IP Application > RIP
LABEL DESCRIPTION
Active Select this check box to enable RIP on the OLT.
Distance Enter a number from 10 to 255 to specify the administrative distance that is assigned to routes
learned by RIP.
The lower the administrative distance value is, the more preferable the routing protocol is. See
Section 41.1.1 on page 330 for more information about administrative distance.
Note: You cannot set two routing protocols to have the same administrative distance.
Index This field displays the index number of an IP interface.
Network This field displays the IP interface configured on the OLT.
Refer to the section on IP Setup for more information on configuring IP domains.
Direction Select the RIP direction from the drop-down list box. Choices are Outgoing , Incoming , Both and
None .
Version Select the RIP version from the drop-down list box. Choices are RIP-1 , RIP-2B and RIP-2M .
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.