GETTING STARTED
16
Z-800F Instructions for Use
P/N 800F-IFU-2602, Rev. O
LOADING PRIMARY ADMINISTRATION SET
Preparing the Primary Solution Container
Prepare the primary solution container in accordance with the
manufacturer’s directions for use.
Preparing the Primary Administration Set
Use only Zyno IV Administration Sets (refer to
Approved
Administration Sets
section for a list of compatible sets).
Open the administration set package, remove the set and close
the roller clamp.
WARNING: Make sure to close Roller Clamp before
removing IV Administration Set from Z-800F Infusion
Pump.
Loading Primary Administration Set
1.
Make sure the Anti-Free Flow Pinch Clamp is attached
on the primary set and it’s in open position. (see picture
“Step 1”)
2.
Insert the Set Spike into prepared fluid container
following accepted clinical procedure, and hang the
container approximately 20 inches above the Infusion
Pump.
3.
Fill the Drip Chamber to 1/3 full by squeezing it.
4.
Open the Roller Clamp slowly to prime tubing. Invert
and tap the back Check Valve and any luer lock sites to
clear the air from the IV Administration Set.
5.
Close the Roller Clamp and the Pinch Clamp.
6.
Close the pump door. Turn on the pump. After the pump
has finished the power-on-self-test, open the pump door.
7.
Using a thumb, firmly push the metal button of the Anti-
Free-Flow Module, slide the Clamp into the Clamp
Holder from the top (pay attention to the orientation of
the clamp) and release the button. (See picture “Step 7”)
8.
Using a fingertip, firmly push the tubing into the gap of
the tubing guides on the Pumping Fingers. (See picture
“Step 8”)
9.
Using a fingertip, firmly push the tubing into the gap of
the Air-in-Line Sensor. (See picture “Steps 9 & 10”)
10.
Align the tubing on top of the gap of the Free Flow
Clamp. Do not force the tubing into the clamp. The
tubing will be loaded into the Free Flow Clamp
automatically when the pump door is closed.
11.
Close the pump door by pushing down the pump door
handle. (See picture “Step 11”)
Step 1
Step 7
Step 8
Step 9 & 10
Step 11