Zurich 56218, Руководство пользователя

Страница: 21 / 101

Using the Scan Tool
ERASING DIAGNOSTIC TROUBLE CODES (DTCs)
For technical questions, please call 1-888-866-5797.
19
If the definition for the currently displayed code is not available,
an advisory message shows.
I/M MONITOR STATUS icons are not displayed when using
the Network Test function.
In the case of long code definitions, a small arrow is shown
in the upper/lower right-hand corner of the code display
area to indicate the presence of additional information.
n
If no codes are present, the message "No ( system name )
DTC’s are presently stored in the vehicle’s computer" shows.
Choose System Menu to return to the System Menu.
5.
If more than one code was retrieved press DTC/FF to display
additional codes one at a time.
n
Whenever the Scroll function is used, the Scan Tool’s
communication link with the vehicle’s computer disconnects. To
re-establish communication, press POWER/LINK again.
6.
When the last retrieved DTC has been displayed and DTC/FF is pressed,
the Scan Tool returns to the first code.
n
To exit the enhanced mode, choose System Menu to return to the
System Menu. Select Global OBD , then press ENTER to
return to the Global OBD2 mode.
ERASING DIAGNOSTIC TROUBLE CODES (DTCs)
When the Scan Tool’s ERASE function is used to erase DTCs
from the vehicle's on-board computer, "Freeze Frame" data
and manufacturer-specific-enhanced data are also erased.
Unlike other codes which can be removed from the vehicle's
control module, PERMANENT codes cannot. This holds true
regardless of the tool being used or color of the status LED
display. PERMANENT codes will automatically erase when the
control module no longer detects the fault that originally
caused the code.
If you plan to take the vehicle to a Service Center for repair, DO NOT
erase the codes from the vehicle's computer. If the codes are erased,
valuable information that might help the technician troubleshoot the
problem will also be erased.
Erase DTCs from the computer's memory as follows:
When DTCs are erased, the I/M Readiness Monitor Status
program resets the status of all Monitors to a not run condition. To
set all Monitors to a DONE status, an OBD2 Drive Cycle must be
performed.
1.
If not connected already, connect the
Scan Tool to the vehicle's DLC, and turn
the ignition "On.” (If the Scan Tool is
already connected and linked to the
vehicle's computer, proceed directly to
step 3. If not, continue to step 2.)
2.
Perform the Code Retrieval procedure
as described on page 6.