7. Autodesk - ADI 4.2 Display Drivers
48
also saved as part of your drawing file, so you only need to execute it once per drawing.
You may even want to set REGENAUTO off in your ACAD.DWG drawing template so
that all your drawings are created with REGENAUTO set off.
Third-Party Software
If you are having trouble with TurboDLD
Classic and third-party AutoCAD applications,
be sure that the third-party application supports ADI 4.2. In order to use the ADI 4.2
specification, third-party applications require new T-Drivers and therefore must be
revised. If an application does not specifically say that it is ADI 4.2 compatible, it
probably is not. Check with the manufacturer to be sure.
If your third-party application is ADI 4.2 compatible and you are having trouble using
TurboDLD
Classic, try running AutoCAD without the third-party application to try to
isolate the problem. Also, try the third-party application with the VESA compatible driver
shipped with AutoCAD. This also helps to isolate the source of the problem.
Also note that any third-party TSR that needs to access the display may not work
properly when using AutoCAD with any advanced ADI display driver, especially if the
TSR switches graphics modes. Most TSRs do not support the same graphics platforms
as TurboDLD
Classic and therefore are not able to accommodate mode switching back
and forth.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
