ZETRON 4000 Series, Руководство по установке

Страница: 256 / 418

IntegratorRD Workstation Installation
256 025-9533Y

To change the language keyboard selection
1. Click on the EN icon at the right side of the taskbar and select CH .
2. There is a Chinese Language bar displayed at the left bottom corner of taskbar.
3. The keyboard is now ready for Chinese entry.
Serial Port Assignments
The dual RS-422 serial communications card delivered with the IntegratorRD Workstation
(P/N 905-0178), is a “PCI” card. This card automatically assigns the port addresses and
interrupt configurations using “Plug and Play.” Typically Windows will assign the next
available COM ports. If the computer has two on-board RS-232 ports assigned to COM1
and COM2, then the two RS-422 ports are assigned COM3 and COM4. These
assignments will vary from computer to computer depending on the exact hardware.
To view the assigned ports in Windows XP, use the Device Manager (click Start, Control
Panel, System, Hardware, Device Manager
).
To view the assigned ports in Windows 7, use the Device Manager (click
Start, Control
Panel, System and Security, System, Device Manager ).
Configuring Integrator Radio Dispatch Software Settings
If the system was purchased as individual components, the Integrator Radio Dispatch
application settings must be configured. The basic configuration settings are assigned
when the application is first started. When the application starts it will present the entry
screen shown in Figure 48 .
To reopen the settings later (any time the application is running), click the “Z” icon
located on the Title Bar and select
Settings
. Alternatively, right-click anywhere in the
Title Bar and select Settings .
Serial Port Settings
Table 93 shows the default console serial port settings.
Table 93: Serial Port Settings
Port ID Port Baud Rate Note
CIC COM3 9600 1
Audio Panel
COM4 9600 1
Recall Recorder (Optional) None 9600 2
CAD I/F (Optional)
None 9600 3