ZETRON 4000 Series, Руководство по установке

Страница: 33 / 418

33
Model 4048 CCE Set Up
Table 4: Console Cardcage Power cable
Table 5: Channel Cardcage Power Cable
Wiring the Model 4048 Power Supply

To wire the power supply
1. Connect AC input power to the modular AC input jack on the back of each power
supply.
2. Connect 12 V
DC
power on the screw-terminal block on the back of each power
supply.
Both AC and DC inputs may be connected at the same time where the DC input
provides a backup to the AC power source.
3. Connect the power cables (three wire bundles) exiting from the back of each
Model 4048 power supply to each cardcage Refer to Figure 10 .
4. Although the power supplies are factory adjusted, you may want to further adjust
them once they are connected to load. See Adjusting the Power Supply on page 34.
Pin Color Purpose
1 Purple Not Used
Connector Part Numbers:
• Connector: 401-0116
• Hood: 401-0117
Please check both connector
markings and the silk screen
on the cardcage to ensure
proper alignment before
installing cable.
2 White Error Signal
3 Yellow +12 V
DC
4 Blue +5 V
DC
5 Brown Ground
6 Black Ground
7 Black Ground
8 Brown Ground
9 Blue +5 V
DC
10 Yellow +12 V
DC
11 Grey -12 V
DC
12 Green Not Used
Pin Color Purpose
1 Yellow +12 V
DC
Connector Part Numbers:
• Connector: 401-2649
• Hood: 401-2650
Please check both connector
markings and the silk screen
on the cardcage to ensure
proper alignment before
installing cable.
2 Red +5 V
DC
3 Brown Ground
4 Black Ground
5 Black Ground
6 Brown Ground
7 Red +5 V
DC
8 Yellow +12 V
DC