ZETRON 4000 Series, Руководство по установке

Страница: 214 / 418

Console Programming System
214 025-9533Y
4. Configure the ANI decode settings as needed. The following table explains each
setting:
5. Click Done when you are finished.
Display Operation
The display of each position is configurable to show time of day in 12-hour or 24-hour
format. Alternatively, the display can show “- - - - -” (dashes) to prevent confusion with a
master site clock.

To configure Display Operation
1. Click
Edit, Position Configuration
.
Operating Mode Select the desired operating mode:
• No ANI Display - ANI is not displayed on this position.
• Selected Channels - ANI is displayed at this position for select channels
only.
• Specified (Fixed) Channels - ANI is displayed at this position for
configured channels only. Configuration is performed in this same
dialog box, in the ANI Channel Select area. *
• All Channels - ANI is displayed at this position for all channels.
Unmute Channel Upon
Receiving ANI
Select
Yes
to enable channels to be automatically unmuted when an ANI is
received. If channels are already unmuted, this has no effect.
Primary Address
Secondary Address Each console has two ANI addresses, a primary and a secondary. Normally
the primary address is used to select an individual console while the
secondary address is used to provide a group call to all consoles. For a
group call, the secondary addresses should be set the same for all of the
positions in the system.
Enter the primary address by entering up to six digits in the
Primary
Address field. Enter the secondary address in the same manner. The
following characters are valid digits “0123456789ABCD#*”.
Timeout Period The timeout period is the time window between the detection of a valid
address and the last ANI digit accepted.
During operation, new ANIs will only be recognized after the time period
has elapsed after the previous ANI. If the calling unit has automatic ANI
calling, one or two seconds should be sufficient. If the calling unit uses a
manual keypad to enter the ANI address, five seconds is the normal
timeout.
Enter a timeout period from 1 to 10 seconds.
Emergency ANI
Acknowledge
This function makes the console automatically acknowledge the receipt of
an ANI on any selected channel that has this function enabled. Mark the
check boxes to select channels for emergency ANI acknowledgement.
ANI Channel Select Mark the check boxes to enable ANI display on those channels.
* The ANI Channel Select area is only visible and relevant if the Operating
Mode is set to “Specified (fixed) Channels”.