Zennio GetFace IP
Tecnical Support
20
3.1.3
HOUSING CONFIGURATION & Z41 COM (DIRECTORY)
Homes connected to the video intercom system must be configured from
Directory
.
The following features can be set up from this window.
3.1.3.1
USERS
It is necessary to configure, at least, as many users as dwellings that may be called
from the video intercom.
For each user, the corresponding
User Phone Number
should be established
according to the IP of the corresponding Z41 COM. These settings are performed from
Directory
Users.
Up to 10.000 users can be created.
For a single user, it will be also possible to set up as many telephone numbers as Z41
COM devices existing within the dwelling. This requires activating
Parallel call to the
following number
.
In case there are more than three Z41 COM within a home, it will be possible to call to
all of them in parallel if more than one user is defined for that home. In such case, it will
be necessary to activate not only
Parallel call to following number
but also
Parallel
call to following deputy
. In short, a single dwelling can have several users assigned,
however all the Z41 COM defined for a user must belong to the same dwelling.
Example
:
The
format
should be:
sip:irrelevant_identifier@IP_of_the_Z41_COM_device
A valid example would be:
being 192.168.1.101 the IP
address of the Z41 COM.
Note
:
if a keypad (ZVP-KEYPAD) or a touch-display (ZPV-TOUCHD) is added to the
video intercom, the
Virtual Number
field should contain the number to be dialled on
the keypad for the call.
Each user must be added individually by pressing the button
, after which the page
with the user configuration is loaded to fill in the data:
