Zennio GetFace IP
Tecnical Support
22
User Phone Numbers
:
Phone Number
: string with the already described format.
Time Profile
: time range in which call reception is allowed. It is possible to
select a pre-defined profile (see section 3.2.2.1) or set a specific one by
checking the button to the left of the calendar.
Parallel call to following number
: if parallel calling to another number is
required (i.e., in case of more than one Z41 COM in the same house), this
checkbox should be enabled.
User Deputy
: user the calls should be redirected to in the event of not
being the current user available. If
Parallel to following deputy
is
enabled, all calls will be transmitted in parallel to both the current user and
the deputy. This option can be useful when there are more than three Z41
COM in the same house.
User activation
: user activation / deactivation code and current status (only
for the ZVP-KEYPAD module).
Access Settings:
(simple by default), which is based on combining an RFID
card along with a code to be typed for the door opening (for the ZVP-
KEYPAD, ZVP-RFSMN or ZVP-TOUCHD modules). Time profiles are
allowed for each direction (entry or exit).
User Codes
: user private code for the switch opening. Time profiles can be
established to restrict its application. Only for the ZVP-KEYPAD module.
Note
:
the corresponding switch must be enabled in
Hardware
Switches
(see section 3.1.4)
.
User Cards
: ID of the user access card and time profile that will remain
active. Two cards allowed per user. Only for the ZVP- RFSMN module (see
section 3.1.9).
3.1.4
SWITCHES CONFIGURATION
It is possible to configure the opening of electric locks linked to Zennio GetFace IP.
This allows controlling them from Z41 COM (up to three electric lock can be enabled).
For instructions on how to wire the lock system to Zennio GetFace IP please refer to
section 2 and to datasheet of the device.
