Zener MSC-3, Инструкция по эксплуатации

Страница: 48 / 158

IM00120
34
IM00120
Quick Setup for Config 3.
STEP 3.
Choose your speed reference and connect it as shown.
Speed control from an external potentiometer
This is typically used for simple manual speed
control. See also Console Reference below.
MSC - 3 Control Board
1k to 10k ohm
potentiometer
11 10 9 8 7
SCN Vref IN+ IN- COM
Speed control from an external signal
Go to the F00 REFERENCES menu and select
F01 REMOTE REF. Press Enter. Use the arrows to
display the options. Press Enter when AI910,11) is
displayed. Press ESC.
Go to the G00 INPUT/OUTPUT menu and select
G02 AI(10,11). Set G020 for the type of input
signal (mA or voltage). Set G021 Min Input and
G022 Max Input to reflect the range signal,
typically 4-20mA or 0-10V. For more information,
see page 89
+
-
MSC - 3 Control Board
8 9 10 11
IN+ Vref IN- SCN
Preset speed
This provides a single fixed speed.
Go to the F00 REFERENCES menu and select
F01 REMOTE REF. Press Enter. Use the arrows
to display the options. Press Enter when PRESET
1 is displayed. Press Enter again. Now set your
desired speed. Press Enter. No speed reference
wiring is necessary.
Console reference
This uses the Up and Down arrows on the front
panel to control the speed.
Go to the F00 REFERENCES menu and select
F01 REMOTE REF. Press Enter. Use the arrows to
display the options. Press Enter when CONSOLE
is displayed. No speed reference wiring is
necessary.