Zener MSC-3, Инструкция по эксплуатации

Страница: 39 / 158

IM00120 25 IM00120
MSC-3 Instruction Manual
STEP 4
Follow the instructions on page 47 for MSC-3 startup, setting the parameters
according to the table below. Alternate values may be used to suit the application.
See the H00 PID Control beginning on page 113 for additional information on PID
configuration and tuning.
Menu Menu Item Suggested Setting
Page for detailed
information
G00 INPUT/OUTPUT G01 Inpt fxn CFG
(Input terminal
configuration) I00 FWD & LATCH = D3(4) (default) 90
I02 ~STOP = D2(3) (default) 91
I07 RESET = D1(2) (default 92
I11 REMOTE = D4(5) (default) 93
G00 INPUT/OUTPUT G03 RL1 G030 RL1 Signal = RUN (default) 98
G04 Rl2 G040 RL2 Signal = TRIP (default) 100
B00 MOTOR B01 MOTOR VOLTS Motor nameplate voltage 71
B02 MOTOR AMPS Motor nameplate amps 71
B03 MOTOR HZ Motor nameplate frequency 71
B04 MOTOR RPM Motor nameplate RPM 72
D00 PROTECTION D01 CURRENT LIM Motor nameplate c10% 78
D02 I2t Thermal overload Motor nameplate current 78
E00 STOP/START E03 AUTO RESTART E030 ARs ALLOWED = 5 82
E04 Reset by PF ENABLED 83
F00 REFERENCES F01 REMOTE REF PID OUTPUT 85
F10 PRESETS F100 PRESET 1 = required pressure (as % of transducer full scale) 88
H00PID Control H06 SV Choice F100 Preset 1 114
H07 PV Choice AI(32,34) 115
C00 PERFORMANCE C03 RAMP C030 ACCEL TIME = 1 sec 74
C031 DECEL TIME = 1 sec 74
STEP 5 Now connect the wire to terminal 6.
End of Procedure