Zener MSC-3, Инструкция по эксплуатации

Страница: 45 / 158

IM00120 31 IM00120
MSC-3 Instruction Manual
STEP 4
Follow the instructions on page 47 for MSC-3 startup, setting the parameters
according to the table below. Alternate values may be used to suit the application.
Menu Menu Item Suggested Setting
Page for detailed
information
G00 INPUT/OUTPUT G01 Inpt fxn CFG
(Input terminal
configuration) I02 ~STOP = D1(2) 91
I00 FWD & LATCH = D2(3) 90
I09 JOGFWD = D3(4) 93
I10 JOGREV = D4(5) 93
G00 INPUT/OUTPUT G03 RL1 G030 RL1 Signal = RUN (default) 98
G04 Rl2 G040 RL2 Signal = TRIP (default) 100
B00 MOTOR B01 MOTOR VOLTS Motor nameplate voltage 71
B02 MOTOR AMPS Motor nameplate amps 71
B03 MOTOR HZ Motor nameplate frequency 71
B04 MOTOR RPM Motor nameplate RPM 72
D00 PROTECTION D01 CURRENT LIM Motor nameplate c10% 78
D02 I2t Thermal overload Motor nameplate current 78
D03 REVERSE ENABLED 80
E00 STOP/START E04 Reset by PF ENABLED 83
F00 REFERENCES F01 REMOTE REF AI(10,11) or PRESET or CONSOLE as selected in Step 3. 85
F04 JOGFWD REF F100 PRESET 1 86
F05 JOGREV REF F100 PRESET 1 86
F10 PRESETS F100 PRESET 1 = 10% (or desired jog sped) 88
C00 PERFORMANCE C03 RAMP C030 ACCEL TIME = 10 sec 74
C031 DECEL TIME = 10 sec 74
STEP 5 Now connect the wire to terminal 6.
End of Procedure