Zeiss OPMI Lumera i, Инструкция по эксплуатации

Страница: 95 / 184

Version 8.0
G-30-1720-en
Page 95
OPMI Lumera i Operation
• Check the lamp brightness.

The lamp brightness can be varied (see Page 107).
Brightness adjustment has an effect on the surgical field illumination.
• Check the lamps

Primary lamp and backup lamp are both intact.
• Check the stand for secure positioning

The locking tabs of at least two casters have been pressed and prevent
the stand from starting to move by itself (see Page 81).
• Check the user settings.

The correct user profile has been selected and the settings have been
checked (see Page 103).
• Check the unobstructed movement of the system.

The system has been positioned in such a way that it can be moved
away from the patient at any time.
• Check foot control panel

Suspension system and surgical microscope must perform the specified
functions (see Page 110).
NOTE Risk of injury when tilting the surgical microscope!
If the surgical microscope is tilted heavily, the co-observation tube may swing
downward unintentionally, or an accessory attached to the surgical microscope
may swing in unintentionally.
This can cause contact with and injury to the patient.
• Always use extreme caution when adjusting the surgical microscope.
– Hold onto the surgical microscope firmly.
– Loosen the friction knob only a little.
– To the extent possible, tilt the surgical microscope only by a small
angle range.
– Finally, tighten the friction knob firmly again.