31
EN_40_070_0011I | Service Manual | Lamp replacement and calibration - Corona extreme
Replacing the halogen lamp
Lamp Replacement and Calibration Corona extreme
9
Install a new halogen lamp
Bring the hole on the edge of the lamp cap
4
in line with the counterbore in
the lamp housing
2
(red line in the diagram below).
Insert the new halogen lamp
3
carefully into the opening of the reflector
holder
1
.
Tighten the three Torx screws
5
on the lamp cap. Use a TX 10 Torx
screwdriver for this.
Fig. 32
4
1
3
2
5
Installing a new halogen lamp
10
Connect lamp cable and adapter cable
Connect the lamp cable
1
with the adapter cable
2
.
Fig. 33
1
2
Connecting lamp cable and adapter cable
