28
Lamp replacement and calibration - Corona extreme | Service Manual | EN_40_070_0011I
Replacing the halogen lamp
Lamp Replacement and Calibration Corona extreme
3
Remove the lamp holder
Unscrew the two Torx screws
1
from the lamp holder. Use a TX 25 Torx
screwdriver for this.
Remove the entire lamp holder – consisting of the lower lamp holder ring
3
and upper lamp holder ring
4
together with the old halogen lamp
2
–
carefully upwards.
Fig. 27
1
3
2
4
Removing the lamp holder
4
Changing type A lamp to type B lamp
Note
IMPORTANT NOTE ON LAMP REPLACEMENT
If the firmware has been updated from Rev.2 to Rev.3, it is essential to use a
type B halogen lamp.
It is no longer possible to install a type A halogen lamp.
Put all disassembled type A lamps aside. These are no longer needed.
