30
Lamp replacement and calibration - Corona extreme | Service Manual | EN_40_070_0011I
Replacing the halogen lamp
Lamp Replacement and Calibration Corona extreme
7
Mount the reflector holder
Align the hole in the reflector holder
4
and the centerbore in the lamp
housing
5
(red line in the diagram below).
Place the reflector holder
2
onto the lamp housing centrally above the
reflector.
Provisionally screw the two fixing screws
3
only half way into the threaded
holes in the lamp housing
1
. Use a TX 25 Torx screwdriver for this.
Fig. 30
3
2
1
5
4
Mounting the reflector holder
8
Center the reflector
Insert the mounting tool
3
into the reflector holder
1
. This centers the
reflector within the reflector holder.
Now tighten the two fixing screws which are already screwed in halfway
2a
-
2b
. Use a TX 25 Torx screwdriver for this.
Remove the mounting tool
3
from the reflector holder
1
.
Fig. 31
3
1
2a
3
2b
Centering the reflector
