7-10
IM 704420-01E
7.4 Initializing the Setup Information
Explanation
The following setup information can be initialized to the factory default settings.
Item
Factory Default Settings
Measurement Function
Item under measurement
D-to-C jitter
Manual setting of the
×
N speed (3T jitter)
1.0
Polarity of the data signal (3T jitter)
Positive
Slope of the data signal (D-to-C jitter)
Rising slope
Slope of the clock signal (D-to-C jitter)
Rising slope
Gate type
105
Manual setting of the gate time
1000.0 ms
Arming type
Auto arming (internal arming)
Slope of the external arming signal
Unselected
Arming delay setting
0.0 ms
ON/OFF condition of inhibit
OFF
Polarity
Unselected
ON/OFF condition of the equalizer
OFF
Trigger mode type
Auto mode
Slice level
0.000 V
ON/OFF condition of the PLL circuit
OFF
Phase difference adjustment value
0.0 ns
Meter scale type
Jitter ratio
Scale
10% scale
Numeric display type (jitter, jitter ratio, or average value)
Jitter ratio
ON/OFF condition of the numeric display
ON
DC output mode
Jitt
Upper limit of the jitter ratio output range
25.00%
Lower limit of the jitter ratio output range
0.00%
Determination level
12.50%
Average coefficient of the DC output filter
1
Jitter ratio correction coefficient
α
1.0000
Jitter ratio correction coefficient
β
0.000
For the following setup information, the initialized information varies depending on the
initialization method.
Item
Initialization to Factory
Initialization of the Current
Default Settings
Setup Information
Setup information stored
All the setup information (preset
The stored setup information
to the internal memory
numbers 0 through 6) are initialized
is not initialized.
to factory default settings.
GP-IB address
1
The GP-IB address is not
initialized.
Note
The communication command “*RST” initializes the current setup information.
