7-6
IM 704420-01E
7.2
Outputting Other Signals
CAUTION
Do not apply external voltage to the output connector. This may cause damage
to the TA120E.
Connecting the Cable
Connect a BNC cable to the appropriate output connector on the rear panel of the
TA120E.
Monitor output of RF signals or monitor output of equalized RF signals
You can output the RF signal that is applied to the RF input connector directly to the
monitor output on the rear panel. If the equalizer is activated, the equalized RF signal
is output.
Item
Specifications
Output impedance
50
Ω
(typical value*)
Output level
When the monitor equipment receives the signal at an input impedance
of 50
Ω
, the output level is as follows:
• When the equalizer is OFF
• Approximately 1/4 of the RF signal (within
±
5 V) when the trigger
mode is set to manual mode.
• Approximately 4/5 of the RF signal (within
±
5 V) when the trigger
mode is set to auto or auto + manual mode.
• When the equalizer is ON
Approx.
±
0.5 V
*
The typical value is a representative or standard value. It is not a warranted value.
(Monitor
output connector)
Monitor output circuit
MONITOR OUT
EQUALIZED RF/
(50
Ω
)
–5 V
+5 V
50
Ω
